![]() ![]() To restart the Application Server, use the following command: ISE-LAB/admin# application start iseĪ variation of this command starts the application in safe mode: ISE-LAB/admin# application start ise safeįrom the Cisco documentation, the purpose of safe mode is But rather than restart the server, you can stop or start a single process from the command line. One option is to simply restart the server with a reload command. For some reason it gets stuck at Initializing. ![]() On many occasions I’ve had all the processes start just fine except the Application Server. If this is the case, give it a few more minutes. If the server just rebooted, many of the services will still be in a “not running” state. If the Admin portal still doesn’t load, log into the console and run this command to see which applications are still initializing or not running: ISE-LAB/admin# show application status ise Even if you might be able to ping ISE, give it a couple more minutes. In this post I’ll go over a couple commands that can help.įirst, I’ve found that the web service takes a few minutes to start after the server boots. This means the Admin portal is unavailable, though ISE may be working properly otherwise. Once in a while the Cisco ISE web service doesn’t start after a reboot of the server, and though less frequent, sometimes the service just stops in a running production server.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |